Skip to main content

Beach infrastructure

Equal access

Requirements for the integration of equal access for all users

The Disability Discrimination Act (DDA) defines ‘premises’ as the whole of the built environment and includes existing buildings, new or proposed buildings, transport systems, car parks, pathways, and public parks and gardens.

Note: Consult an access consultant accredited by the Association of Consultants in Access Australia (ACAA).

Elements required for equal access

  • Embellishments must be designed in accordance with AS 1428 Design for access and mobility.
  • Install fences at a minimum 500 mm offset from the edge of any pathway (not for a sand or turf floor beach access path), to provide safe clearance for pedestrians.
  • Consider installing a luminance strip of paint or tape (depending on the fence material) at locations along the fence (on posts at eye level where possible) to improve definition for people with vision impairment.
  • Equal access handrail must have a round profile (must comply with AS 1428 Design for access and mobility). Material should be stainless steel, galvanised steel, or aluminium. Stainless steel is recommended in sunshine coast wide parks, district high use parks where applicable. 
    • include equal access handrail to new beach access fencing where possible. Handrails assist people of varying ability to negotiate a soft sand surface. 
    • handrails are not recommended in the following beach areas due to constant sand dune level changes:
      • ‘low pedestrian usage beach access’
      • some ‘medium pedestrian usage beach accesses’.
    • equal access handrail must include a continuous round profile with no hand obstructions.
  • Include luminance contrast provision to all beach access and fence components, where possible. Fence post, rail and infill strand/mesh/shade cloth must not disappear into the background against which it is viewed, but must be visible to vision impaired persons (VIPs).
  • Stairs, ramps and walkways must comply with AS 1428.1 and AS 1428.4.1, except tactile ground surface indicators are not required on beachside approaches to these fixtures and features.
  • Select beach access surface material to provide equal access where possible, particularly at sites where beach wheelchairs are used or may be used in future.
  • Connect accessible beach accesses to an existing pathway where possible to create a continuous accessible path of travel from a dedicated disabled parking space onto the foreshore.
  • Beach wheelchairs are available at various locations including, businesses and surf lifesaving clubs across the Sunshine Coast. 
  • Avoid finished height difference between a concrete slab and adjoining surfaces to prevent trip hazards and to prevent ‘tramlining’ of pram, bicycle and wheelchair wheels.

See LIM Handrails and balustrades for further guidance.  

Visual/sensory wayfinding

  • For people with a vision impairment, provide a minimum 30% luminance contrast between objects and the background they are viewed against, for ease of identification.
    • Where luminance contrast may not be achieved (such as grey aluminium furniture on grey concrete), luminance contrast can be addressed by introducing colour into the ground surface providing a minimum 30% luminance contrast with the embellishment base, resulting in the embellishment being more visible for people who have low vision.
  • Products such as fence strands, fence components and shade cloth need to be highly visible against the background sand dunes or planting, for example black.
  • 30% luminance contrast is required between fence materials and the background against which they are viewed (the sand/vegetation).
Page payload data

This component is currently in development

 

Sunshine Coast Open Space Landscape Infrastructure Manual (LIM) DISCLAIMER

Disclaimer

Information contained in this document may change without notice and you should use the current material available from Council’s website and not rely on material previously printed or stored by you.

All figures and diagrams are intended to be used as an aid to design and include Council’s preferred elements but they are not intended to be prescriptive and may need to be varied as dictated by site specific factors. While Council has exercised reasonable care in preparing this document, it does not warrant or represent that it is accurate or complete. The Council will not accept responsibility for any loss, damage, cost or expense that you may incur as a result of the use of or reliance upon any material contained in this document.

This document is produced to convey general information and is not intended to constitute advice whether professional or legal. Any reference to legislation in this document is not an interpretation of the law. It is to be used as a guide only. Consult relevant authority websites for current documents, revisions and amendments.

Where a particular product or supplier is profiled in this document, Council is NOT nominating this product or supplier as the selected choice. Product/supplier information has been provided to allow users to source products which contain the correct elements required for Council embellishments. Each product profiled states ‘or equivalent’ which means that different products may be supplied provided they satisfy the identified performance criteria, recommended standards, equal access guidance and product specifications.

Product design, manufacture and installation requires appropriately qualified people to provide site specific solutions to ensure the embellishment is appropriately adapted to local conditions and data.

This document does not override requirements stipulated in a development approval. Project specific variations may be appropriate as a result of site, environmental or other constraints. Any variations to these standards must be approved in writing by council prior to commencement of variation works. Components of this document may be used within a contract document but users should undertake their own investigations to confirm the information is suitable for this purpose.

Drawings contained in this document are NOT FOR CONSTRUCTION.

Details in this document are deemed to be the minimum standard and the user may wish to apply a higher standard subject to approval by council.

Acknowledgements

Council wishes to thank all contributors and stakeholders involved in the development of this document.

Copyright

Sunshine Coast Regional Council (Council) supports and encourages the distribution of its material however, copyright protects this document. Council has no objection to this material being reproduced but only if council is recognised as the owner of the copyright and this material remains unaltered.

https://www.sunshinecoast.qld.gov.au[email protected]07 5475 7272

Sunshine Coast Open Space Landscape Infrastructure Manual (LIM)

 | 

© LIM 2024 – 2026

 | 

Version 0.0.38.beta

 | 

Last Updated: 01/04/2026 12:27 AM

Preview